Mail Archives: geda-user/2012/12/23/12:49:55

X-Authentication-Warning: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
Date: Sun, 23 Dec 2012 18:50:57 +0100
From: Leonardo Guardati <leonardo AT guardati DOT it>
To: geda-user AT delorie DOT com
Subject: Re: [geda-user] PCB: gcode export: missing drill file
Message-ID: <>
References: <20121223154752 DOT GC2518 AT guardati DOT it>
<447737F3-9903-4F7B-92E9-3637E2339073 AT jump-ing DOT de>
MIME-Version: 1.0
In-Reply-To: <>
User-Agent: Mutt/1.5.21 (2010-09-15)
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com

On Sun, Dec 23, 2012 at 05:40:03PM +0100, Markus Hitter wrote:
> Am 23.12.2012 um 16:47 schrieb Leonardo Guardati:
> >I'm using PCB 20110918.
> There were a whole bunch of enhancements over the last year, so
> upgrading to a version compiled from recent sources would give you a
> lot of features.

After I finish this work I will try the last version!

> The drill file should be name.gcode.drill.cnc. Is there no bottom
> side of your board? Not sure wether it works without one. And drills
> are drilled from the bottom side, so, mirrored to match the top
> side. Conventions here might be a bit more traditional than what the
> SMD-only designer expects :-)

Yes this was the problem, I had nothing on the bottom layer.

And thank you for noting the fact that the drill file is mirrored,
I would have noted it only after drilling in the wrong posistions :P


- Raw text -

  webmaster     delorie software   privacy  
  Copyright 2019   by DJ Delorie     Updated Jul 2019