X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
Date: Sun, 23 Dec 2012 18:50:57 +0100
From: Leonardo Guardati <leonardo AT guardati DOT it>
To: geda-user AT delorie DOT com
Subject: Re: [geda-user] PCB: gcode export: missing drill file
Message-ID: <20121223175057.GA26189@guardati.it>
References: <20121223154752 DOT GC2518 AT guardati DOT it>
 <447737F3-9903-4F7B-92E9-3637E2339073 AT jump-ing DOT de>
MIME-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline
In-Reply-To: <447737F3-9903-4F7B-92E9-3637E2339073@jump-ing.de>
User-Agent: Mutt/1.5.21 (2010-09-15)
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk

On Sun, Dec 23, 2012 at 05:40:03PM +0100, Markus Hitter wrote:
> 
> Am 23.12.2012 um 16:47 schrieb Leonardo Guardati:
> 
> >I'm using PCB 20110918.
> 
> There were a whole bunch of enhancements over the last year, so
> upgrading to a version compiled from recent sources would give you a
> lot of features.

After I finish this work I will try the last version!


> The drill file should be name.gcode.drill.cnc. Is there no bottom
> side of your board? Not sure wether it works without one. And drills
> are drilled from the bottom side, so, mirrored to match the top
> side. Conventions here might be a bit more traditional than what the
> SMD-only designer expects :-)
> 

Yes this was the problem, I had nothing on the bottom layer.

And thank you for noting the fact that the drill file is mirrored,
I would have noted it only after drilling in the wrong posistions :P


Leonardo.