X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Virus-Scanned:	amavisd-new at neurotica.com
To:	geda-user AT delorie DOT com
From:	"Dave McGuire (mcguire AT neurotica DOT com) [via geda-user AT delorie DOT com]" <geda-user AT delorie DOT com>
Subject:	[geda-user] pcb: pad clearance in polygon?
Message-ID:	<a8d201ee-de06-e251-2ed3-626b933a1b18@neurotica.com>
Date:	Fri, 25 Sep 2020 13:59:11 -0400
User-Agent:	Mozilla/5.0 (X11; Linux x86_64; rv:60.0) Gecko/20100101
	Thunderbird/60.6.1
MIME-Version:	1.0
Reply-To:	geda-user AT delorie DOT com

   Ok, with my outline problem straightened out, I've hit a strange 
issue.  I don't often place components on the solder side of a board, 
but I have to do that today.  I've drawn a footprint for a surface-mount 
component that has three pads.  I placed it on the solder side, and the 
clearance in the copper pour on that side of the board is gone, the pads 
are in direct contact with the pour.  When placed on the component side, 
the ring of clearance is intact as I expected.

   This has to be something dumb but I can't seem to figure out what's 
going on.  Any suggestions?

               Thanks,
               -Dave

-- 
Dave McGuire, AK4HZ
New Kensington, PA

- Raw text -