To: opendos AT delorie DOT com Date: Mon, 5 Mar 2001 16:28:20 -0800 Subject: Re: Hard drive question Message-ID: <20010305.164702.-319187.0.domanspc@juno.com> X-Mailer: Juno 4.0.11 MIME-Version: 1.0 Content-Type: text/plain Content-Transfer-Encoding: 7bit X-Juno-Att: 0 X-Juno-RefParts: 0 From: Robert W Moss Reply-To: opendos AT delorie DOT com I had the same problem some time back with a Seagate drive. I had originally installed it as a LBA drive, but when I switched to another computer I got a choice of CHS/LBA/NORMAL, and each one had a different set of CYL/HDS/SECT. I had forgotten to check the BIOS settings before removing the drive from the old computer and since the info on the drive listed the CHS setting first I selected that. I got the drive mounted but only had the first of 4 Partitions available. Then I went to my old computer and found a cheat sheet I had filled out when I installed the drive. I had installed it as a LBA drive. I searched for the install instruction sheet that came with the drive found an obscure little small print note which said that you must continue to use the same drive type (LBA/CHS/NORMAL) as was originally used or you have to reformat the drive. I tried to switch back to LBA on the drive but it never worked right. The boot sector ended up getting messed up and I was lucky I got my most important files copied off by using the drive as a slave. The drive went belly up a few days later and froze solid. Hope your problem is not that serious. Of course there are some people who would say I got what I paid for by using a Seagate drive, but I have ten others which all work ok, including the 6.3 GIG I am using on this computer. BOB 'DOMAN' MOSS "Eat chocolate every day" On Mon, 5 Mar 2001 20:14:20 -0300 "Alain" writes: > Hi, > > I have met a strange problem last year that meets you description: > > The drive had been installed as LBA and later it was recognized > by the bios and installed as something else (which was default) > What happend is that the disk was not accessible. To correct > it I just used another option in the bios autodetect ... > > I hope this can help > > Alain > > > >Hello All, > > I've got Drdos 7.03 installed on a 486 and a 586 both on drive > C. > > I have a drive D on the 486 on which there are many back-up > files and I > >desire to take this drive D and make it a D drive on the 586. > > It's a slave on the 486 and I have moved it to the 586 also as > slave. > > Its not being seen or not being understood by the 586. The > bios has > >accepted the install of a 2nd drive without a problem but I cannot > use the > >drive it's not being accepted to read and write. I can bring it > back to the > >486 and it works fine there. > > How do I get those files to be seen on the 586 without having > to > >reformat the entire drive on the new machine? > > Thanks, > > Mark > > > > > ________________________________________________________________ GET INTERNET ACCESS FROM JUNO! Juno offers FREE or PREMIUM Internet access for less! Join Juno today! For your FREE software, visit: http://dl.www.juno.com/get/tagj.