Message-ID: <3492EFEC.690@yours.com> Date: Sat, 13 Dec 1997 12:28:28 -0800 From: Dinko Bacun Reply-To: dinko AT yours DOT com Organization: TENDRIKS d.o.o. MIME-Version: 1.0 To: opendos AT delorie DOT com Subject: memmax question Content-Type: text/plain; charset=us-ascii Content-Transfer-Encoding: 7bit Precedence: bulk Hi everybody, I recently installed 7.02 on a 120 Mhz pentium notebook. In the setup, I used the /V switch (in the past 2 years, I installed about 30 ND7, and used memmax in all of them). When I run mem ith shows 615KB for largest executable program size and about 714KB total free dos memory, but when I run memmax it maps the video memory space but the largest exec siye stays at 615 KB and to total DOS memory is reset to 615 KB (which is of no use for me). I recall a few instances previously to have the same problem, but I don't remember if it was solved somehow. The only other nonstandard thing that happens while booting is that EMM reports that A20 line is in use. I tried to use the /GATEA20 switch but to no avail. I wonder whether I should play with CMOS settings, although I am somewhat reluctant as I installed the 7.02 over Win95 (both coexit ok) Any ideas? TIA dinko --------------------------------------------------------------------- Dinko Bacun TENDRIKS d.o.o. (+385) 01 4680-900 Bijenicka 13A 4680-901 10000 ZAGREB 4680-896 CROATIA BBS: 4680-898 Email: dinko AT yours DOT com ---------------------------------------------------------------------