X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f X-Recipient: geda-user AT delorie DOT com From: Donald Tillman Content-Type: text/plain; charset=us-ascii Subject: [geda-user] Parts with internally connected pins Message-Id: Date: Fri, 12 Jun 2015 08:17:03 -0700 To: geda-user AT delorie DOT com Mime-Version: 1.0 (Mac OS X Mail 8.2 \(2098\)) X-Mailer: Apple Mail (2.2098) X-Sonic-CAuth: UmFuZG9tSVZbqdRUWT6P85FuCn9FPJjDGTZgbIhbZEemT8LoSznQOxYxOvKZ5amYvk89FkZK93UE0VhsTQXa2iXcY3ZuMKhf X-Sonic-ID: C;4NXFFhYR5RGutvjYVPtzAg== M;sGgGGRYR5RGutvjYVPtzAg== X-Spam-Flag: No X-Sonic-Spam-Details: 0.0/5.0 by cerberusd Content-Transfer-Encoding: 8bit X-MIME-Autoconverted: from quoted-printable to 8bit by delorie.com id t5CFHKvs016475 Reply-To: geda-user AT delorie DOT com Hi, What would be the best way to deal with parts that have pins that are internally connected together, and when laying out a board you can freely connect to one, or to the other, or both? And do it in such a way that the pcb Optimize Rats Nest command doesn't complain. My specific case is the Bourns PTV09 vertically mounted pot. Besides the usual three pins, there are two pins connected to a shield. They're the same piece of metal so it's only necessary to connect to one of them, it doesn't matter which one. I tried a footprint file with the two shield pins with different names but the same number, but the rats nest demands a connection between them. -- Don -- Don Tillman Palo Alto, California don AT till DOT com http://www.till.com