X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Sun, 31 Jul 2016 13:37:38 -0400
Message-Id: <201607311737.u6VHbcJ0024181@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to:
	<CAC4O8c8igjURDrT3bp7qp5t3Lu1Ey-PrBTw--w7Y5o54=ZpWyA AT mail DOT gmail DOT com>
	(geda-user AT delorie DOT com)
Subject: Re: [geda-user] pcb: ARC bug
References: <alpine DOT DEB DOT 2 DOT 00 DOT 1606041445000 DOT 28818 AT igor2priv>
 <575325A6 DOT 5020802 AT iee DOT org> <nj0afa$sel$1 AT ger DOT gmane DOT org> <5753CE50 DOT 1020405 AT iee DOT org>
 <nj1fn4$tk0$1 AT ger DOT gmane DOT org> <alpine DOT DEB DOT 2 DOT 00 DOT 1607311702430 DOT 7286 AT igor2priv> <201607311616 DOT u6VGGhr9020892 AT envy DOT delorie DOT com> <CAC4O8c8igjURDrT3bp7qp5t3Lu1Ey-PrBTw--w7Y5o54=ZpWyA AT mail DOT gmail DOT com>
Reply-To: geda-user AT delorie DOT com


> Would it make sense to just have an area say 2x in each dimension
> larger than board?  So you can stack parts "next" to what you're working
> on.  IIRC zoom out is clamped something like this so you can't lose
> the board.

The lesstif GUI does that, and the gtk one might too.