X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f X-Recipient: geda-user AT delorie DOT com Date: Mon, 26 May 2014 11:10:45 +1200 From: Lilith Bryant Subject: [geda-user] PCBGL Branch Issues To: geda-user AT delorie DOT com X-Mailer: Balsa 2.5.1-79-g9697477 Message-Id: <1401059445.16491.8@zotlet.(none)> MIME-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Disposition: inline Content-Transfer-Encoding: 8bit X-MIME-Autoconverted: from quoted-printable to 8bit by delorie.com id s4PNB1CY022402 Reply-To: geda-user AT delorie DOT com Peter, Have been testing out this branch on a real job. Mostly it's been a very welcome speed increase, thank you so much for writing this, I hope it makes it into mainline at some point. There is a few oddities, though: A "Rat rings" have overlapping ends which makes for a little dark circle at the 9 o'clock position. Cosmetic and ignorable but a little disconcerting at first. B1 Overlapping pads aren't visible. (These are needed to get reduced paste masks) B2 Vias on pads aren't showing up either, probably same issue as B1