X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Sat, 29 Mar 2014 15:59:52 -0400
Message-Id: <201403291959.s2TJxqMS008550@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to: <20140329193002.242d8329@richard-laptop> (message from Richard
	Bown on Sat, 29 Mar 2014 19:30:02 +0000)
Subject: Re: [geda-user] newbie help please
References: <20140329152452 DOT 20032004 AT richard-laptop>
	<201403291729 DOT s2THTckd003879 AT envy DOT delorie DOT com> <20140329193002 DOT 242d8329 AT richard-laptop>
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk


> I've started again, as it ended up in a bit of a mess, and I can
> remember the rough layout, Still getting a bit of trouble using "j"
> Sometimes it works , others not.  Do you hover over the track to be
> joined to the rectangle , or on the rectangle close to the track.

The 'j' key is used over the track, without the track needing to be
selected.

The 'j' key over the polygon does something different I think.

> I have three crystal filters to go on the board, last time I just put
> vias where the fixing screws and pins are located, where do I find the
> facility to create an element , so I can just drop it on to the board ?

http://www.delorie.com/pcb/docs/gs/