X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
Message-ID: <20140128005339.9636.qmail@stuge.se>
Date: Tue, 28 Jan 2014 01:53:39 +0100
From: Peter Stuge <peter AT stuge DOT se>
To: geda-user AT delorie DOT com
Subject: Re: [geda-user] 0.5mm pitch connector suggestions
Mail-Followup-To: geda-user AT delorie DOT com
References: <CALSZ9grNCBNGwof1bXwyFic92HJ15QxFDUiRT8HfLOVB12Q92w AT mail DOT gmail DOT com>
MIME-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline
In-Reply-To: <CALSZ9grNCBNGwof1bXwyFic92HJ15QxFDUiRT8HfLOVB12Q92w@mail.gmail.com>
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk

Rob Butts wrote:
> 0.5mm pith flat ribbon cable and comes with a small surface mount zif
> connector that I think will be nearly impossible to solder to a circuit
> board.

It's possible to solder by hand with a good eye and a steady hand.

But you could also try manual reflow. Dispense enough solder paste
across all the pads, never mind paste on top of the soldermask, put
the connector in place, and use hot air to reflow the solder paste.

Capillary forces and soldermask rules out shorts and pulls the
connector into position.

Pick a connector with more material and tolerance for higher
temperatures to not accidentally melt it with the hot air.


//Peter