X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Fri, 26 Jul 2013 13:08:11 -0400
Message-Id: <201307261708.r6QH8BdA026224@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to:
	<CALSZ9goWyDGyQd-gmAxWk6d30XKSVjavEQYa3FrWSOB7u7LD9g AT mail DOT gmail DOT com>
	(message from Rob Butts on Fri, 26 Jul 2013 12:54:43 -0400)
Subject: Re: [geda-user] PCB doesn't auto-route
References: <CALSZ9goWyDGyQd-gmAxWk6d30XKSVjavEQYa3FrWSOB7u7LD9g AT mail DOT gmail DOT com>
Reply-To: geda-user AT delorie DOT com


Do you have any ground/power polygons you're trying to route through?
Are all the to-be-routed layers shown?  Did you do "optimize rats" and
make sure all the nets you want are not "disabled for routing" in the
nets dialog?  Are there any messages in the message log?