X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Wed, 3 Jul 2013 15:58:05 -0400
Message-Id: <201307031958.r63Jw5r2025909@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to:
	<CACPio-4vTN=XE8XvJibvfA2JfTCG7JShFjaUMapHst6WGm0GrQ AT mail DOT gmail DOT com>
	(message from Nathan Stewart on Wed, 3 Jul 2013 15:01:12 -0400)
Subject: Re: [geda-user] outline layer not closed
References: <CACPio-4vTN=XE8XvJibvfA2JfTCG7JShFjaUMapHst6WGm0GrQ AT mail DOT gmail DOT com>
Reply-To: geda-user AT delorie DOT com


Try making your workspace a little bigger than the outline.

PCB's "outline detector" just does a flood fill at the corners of the
workspace; if the outline touches those corners it may interfere.