X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
X-Virus-Scanned: amavisd-new at neurotica.com
Message-ID: <5199AB8C.5060501@neurotica.com>
Date: Mon, 20 May 2013 00:50:20 -0400
From: Dave McGuire <mcguire AT neurotica DOT com>
User-Agent: Mozilla/5.0 (X11; Linux x86_64; rv:17.0) Gecko/20130510 Thunderbird/17.0.6
MIME-Version: 1.0
To: geda-user AT delorie DOT com
Subject: Re: [geda-user] ITEAD?
References: <51970516 DOT 6040101 AT neurotica DOT com> <CAL5HA=DVx7-YL=hrUkAzDh18ncWU7ffwmuzyhGUk8dzaZuKzyA AT mail DOT gmail DOT com>
In-Reply-To: <CAL5HA=DVx7-YL=hrUkAzDh18ncWU7ffwmuzyhGUk8dzaZuKzyA@mail.gmail.com>
X-Enigmail-Version: 1.5.1
Content-Type: text/plain; charset=ISO-8859-1
Content-Transfer-Encoding: 7bit
Reply-To: geda-user AT delorie DOT com


  Ahh ok, I've purchased a few things from Seeed; they've done right by me
thus far.  I'll give them a shot as well.  Thanks for the info!

                -Dave

On 05/18/2013 02:13 AM, Jasper wrote:
> Hi Dave,
> 
> I have used seeedstudio's service with gEDA a few times and the boards came
> out good. I don't have experience with itead but I think they're basically
> the same service.
> 
> http://www.seeedstudio.com/depot/fusion-pcb-service-2-layers-p-835.html?cPath=70_71
> 
> Best regards,
> 
> Jasper
> 
> 
> On Sat, May 18, 2013 at 6:35 AM, Dave McGuire <mcguire AT neurotica DOT com
> <mailto:mcguire AT neurotica DOT com>> wrote:
> 
> 
>       Hey folks.  Has anyone here used ITEAD (http://www.iteadstudio.com/) for
>     PCB prototyping runs?  I was wondering how good they are, and if they digest
>     PCB's gerbers ok.
> 
>                     Thanks,
>                     -Dave
> 
>     --
>     Dave McGuire, AK4HZ
>     New Kensington, PA
> 
> 


-- 
Dave McGuire, AK4HZ
New Kensington, PA