X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f Date: Fri, 3 May 2013 16:11:00 -0400 Message-Id: <201305032011.r43KB0dn000664@envy.delorie.com> From: DJ Delorie To: geda-user AT delorie DOT com In-reply-to: <51841219.4010906@buffalo.edu> (sbesch@buffalo.edu) Subject: Re: [geda-user] need advice about copper "keep out" areas References: <5183F1E2 DOT 4000804 AT neurotica DOT com> <5183F419 DOT 3010800 AT estechnical DOT co DOT uk> <5183F787 DOT 8040007 AT neurotica DOT com> <5183FAA0 DOT 3030600 AT estechnical DOT co DOT uk> <51841219 DOT 4010906 AT buffalo DOT edu> Reply-To: geda-user AT delorie DOT com Errors-To: nobody AT delorie DOT com X-Mailing-List: geda-user AT delorie DOT com X-Unsubscribes-To: listserv AT delorie DOT com Precedence: bulk > However, in those cases where there is a copper keep-out in the > middle of the board, polygons don't seem to work. The polygon hole tool didn't work?