X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
Message-ID: <5135CB72.50701@estechnical.co.uk>
Date: Tue, 05 Mar 2013 10:39:46 +0000
From: Ed Simmons <ed AT estechnical DOT co DOT uk>
User-Agent: Mozilla/5.0 (X11; Linux x86_64; rv:17.0) Gecko/20130221 Thunderbird/17.0.3
MIME-Version: 1.0
To: geda-user AT delorie DOT com
CC: Kai-Martin Knaak <kmk AT familieknaak DOT de>
Subject: Re: [geda-user] Stencil tooling holes
References: <51350C42 DOT 2070801 AT estechnical DOT co DOT uk> <20130305054647 DOT 0167672a AT akka>
In-Reply-To: <20130305054647.0167672a@akka>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
Content-Transfer-Encoding: 7bit
X-Authenticated-As: ed AT estechnical DOT co DOT uk
Reply-To: geda-user AT delorie DOT com

On 05/03/13 04:46, Kai-Martin Knaak wrote:
> Ed Simmons <ed AT estechnical DOT co DOT uk> schrieb am  4. March 2013:
>
>> Please could someone offer some advice for placing tooling holes into
>> my design (these are off the edges of the board itself and will only
>> be used for stencil layers)
>>
>> How would you go about this? Is this something I should make a custom
>> footprint for?
> IMHO, a special footprint is the best solution. I attached my preferred
> marks to this mail.
>
> ---<)kaimartin(>---
Thanks Kai-Martin,

That looks good...

Looking at these in PCB, it's not obvious how to view the opening of the 
stencil layer, is this possible?

Thanks for your help,
Ed