X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
Message-ID: <20121011155417.13405.qmail@stuge.se>
Date: Thu, 11 Oct 2012 17:54:17 +0200
From: Peter Stuge <peter AT stuge DOT se>
To: geda-user AT delorie DOT com
Subject: Re: [geda-user] Flex?
Mail-Followup-To: geda-user AT delorie DOT com
References: <20121011143959 DOT 7435 DOT qmail AT stuge DOT se> <1349967212 DOT 2412 DOT 37 DOT camel AT AMD64X2 DOT fritz DOT box>
MIME-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline
In-Reply-To: <1349967212.2412.37.camel@AMD64X2.fritz.box>
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk

Stefan Salewski wrote:
> http://www.delorie.com/pcb/teardrops/
> 
> I am not sure if it works perfectly, someone reported about a
> problem long time ago, I do not know if DJ has fixed that.

http://stuge.se/tears.png

It looks absolutely beautiful for vias and round pads.

I only have pads on the flex board however, and on square pads the
result is not as convincing.

What is the solution? I guess the arcs need to start further out
towards the corners. (One half line width diagonally in from each
corner.)


//Peter