X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f X-Recipient: geda-user AT delorie DOT com X-Injected-Via-Gmane: http://gmane.org/ To: geda-user AT delorie DOT com From: Rupert Swarbrick Subject: Re: [geda-user] footprint with rectangular through holes ? Date: Fri, 20 Jul 2012 19:56:11 +0100 Lines: 28 Message-ID: References: <201207201631 DOT q6KGVUTd003513 AT envy DOT delorie DOT com> <201207201713 DOT q6KHD3EA005891 AT envy DOT delorie DOT com> <50099611 DOT 5070504 AT keensupport DOT net> <201207201733 DOT q6KHXYOm006861 AT envy DOT delorie DOT com> Mime-Version: 1.0 Content-Type: multipart/signed; boundary="=-=-="; micalg=pgp-sha1; protocol="application/pgp-signature" X-Complaints-To: usenet AT dough DOT gmane DOT org X-Gmane-NNTP-Posting-Host: cpc1-cove3-0-0-cust941.3-1.cable.virginmedia.com User-Agent: Gnus/5.130006 (Ma Gnus v0.6) Emacs/24.1.50 (gnu/linux) Reply-To: geda-user AT delorie DOT com --=-=-= Content-Type: text/plain DJ Delorie writes: >> And a question. Does this mean the following image of a connector >> footprint is not supported? > > Right. Most of the fabs we deal with don't support slots anyway, so > we make do without them. However, you can make a line of drill holes that overlap, ending up with a slot with a slightly wavy edge. Rupert --=-=-= Content-Type: application/pgp-signature -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.12 (GNU/Linux) iJwEAQECAAYFAlAJqcsACgkQRtd/pJbYVoapkgP+IsWXI2rGeg6+ARq8CiGpK4n/ UxHuO7x6Tw+GJHvkC0qRqOJIle5Qid8GslN7TELG9kT4knLuyQkf7KpQm+SqN0cU P/HFjoBFotiSSLNdKwO8RJofH3ecGPn6mnpoloqKdvelHA8XaTTV5zdYbHgChbB9 O64IF9eOQEiZfXn+VsE= =uWvK -----END PGP SIGNATURE----- --=-=-=--