X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Thu, 2 Feb 2012 02:41:08 -0500
Message-Id: <201202020741.q127f89A018058@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to: <20120201230802.26c7818c@svelte> (message from Colin D Bennett on
	Wed, 1 Feb 2012 23:08:02 -0800)
Subject: Re: [geda-user] pcb rat line thickness setting?
References: <20120201173334 DOT 1ee6e47d AT svelte>
	<201202020201 DOT q1221rsw004062 AT envy DOT delorie DOT com> <20120201230802 DOT 26c7818c AT svelte>
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk


> Thanks for the tip.  The command-line option works as stated, but
> Pcb.rat-thickness is not accepted in the $HOME/.pcb/preferences
> file -- if I add it, it is ignored and pcb doesn't write it back
> out when it saves the preferences file.

That was from my ~/.Xdefaults.  use rat-thickness in settings or
preferences.