X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Wed, 1 Feb 2012 21:01:53 -0500
Message-Id: <201202020201.q1221rsw004062@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to: <20120201173334.1ee6e47d@svelte> (message from Colin D Bennett on
	Wed, 1 Feb 2012 17:33:34 -0800)
Subject: Re: [geda-user] pcb rat line thickness setting?
References: <20120201173334 DOT 1ee6e47d AT svelte>
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk


Still there...

Pcb.rat-thickness:	3nm
pcb --rat-thickness 3nm laminator.pcb

Note: "nm" is a hint that means "pixels regardless of resolution" for
values less than about 20nm.  It used to be just '3' was enough, but
that defaults to 0.03 mil now, which isn't a "small integer"
internally any more.