X-Authentication-Warning: delorie.com: mail set sender to geda-help-bounces using -f X-Recipient: geda-help AT delorie DOT com X-Mailer: exmh version 2.8.0 04/21/2012 with nmh-1.7+dev X-Exmh-Isig-CompType: repl X-Exmh-Isig-Folder: inbox From: "karl AT aspodata DOT se [via geda-help AT delorie DOT com]" To: geda-help AT delorie DOT com cc: karl AT aspodata DOT se Subject: Re: [geda-help] Footprint for component with different spacing between pins In-reply-to: References: Comments: In-reply-to "Klaus Rudolph (lts-rudolph AT gmx DOT de) [via geda-help AT delorie DOT com]" message dated "Thu, 07 Jan 2021 10:21:44 +0100." Mime-Version: 1.0 Content-Type: text/plain Message-Id: <20210107103351.9E45D832BB55@turkos.aspodata.se> Date: Thu, 7 Jan 2021 11:33:51 +0100 (CET) X-Virus-Scanned: ClamAV using ClamSMTP Reply-To: geda-help AT delorie DOT com Errors-To: nobody AT delorie DOT com X-Mailing-List: geda-help AT delorie DOT com X-Unsubscribes-To: listserv AT delorie DOT com Precedence: bulk Klaus: > I want to be able to place lets say 100nF capacitor with 100mil and > 200mil spacing between pins on my circuit boards. Simple idea is to have > it with 3 pins in the footprint but 2 of the pins have "same signal". > > Have can this be achieved/best practice? Simply let the two pins with the "same signal" have the same pinnumber. E.g.: Element ["" "zz.fp" "" "" 0 0 -0.7mm -2mm 0 100 ""] ( Pin [ 0.000mm -2.540mm 2.100mm 0.500mm 2.500mm 1.100mm "1" "1" "square" ] Pin [ 0.000mm 0.000mm 2.100mm 0.500mm 2.500mm 1.100mm "2" "2" "" ] Pin [ 0.000mm 2.540mm 2.100mm 0.500mm 2.500mm 1.100mm "2" "2" "" ] ElementLine [ -1.410mm -3.950mm 1.410mm -3.950mm 0.320mm ] ElementLine [ 1.410mm -3.950mm 1.410mm 3.950mm 0.320mm ] ElementLine [ 1.410mm 3.950mm -1.410mm 3.950mm 0.320mm ] ElementLine [ -1.410mm 3.950mm -1.410mm -3.950mm 0.320mm ] ) Regards, /Karl Hammar