X-Authentication-Warning: delorie.com: mail set sender to geda-help-bounces using -f X-Recipient: geda-help AT delorie DOT com Date: Wed, 7 Jun 2017 07:09:15 +0200 (CEST) X-X-Sender: igor2 AT igor2priv To: "John Griessen (john AT ecosensory DOT com) [via geda-help AT delorie DOT com]" X-Debug: to=geda-help AT delorie DOT com from="gedah AT igor2 DOT repo DOT hu" From: gedah AT igor2 DOT repo DOT hu Subject: Re: [geda-help] gxyrs with gEDA PCB In-Reply-To: Message-ID: References: <1343213007 DOT 3854008 DOT 1496782855983 DOT ref AT mail DOT yahoo DOT com> <1343213007 DOT 3854008 DOT 1496782855983 AT mail DOT yahoo DOT com> <20170606230904 DOT 1F24E807466D AT turkos DOT aspodata DOT se> User-Agent: Alpine 2.00 (DEB 1167 2008-08-23) MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII; format=flowed Reply-To: geda-help AT delorie DOT com Errors-To: nobody AT delorie DOT com X-Mailing-List: geda-help AT delorie DOT com X-Unsubscribes-To: listserv AT delorie DOT com Precedence: bulk On Tue, 6 Jun 2017, John Griessen (john AT ecosensory DOT com) [via geda-help AT delorie DOT com] wrote: > On 06/06/2017 06:09 PM, karl AT aspodata DOT se wrote: >> Why don't you ask macrofab, https://factory.macrofab.com/help/k28u1k >> says: >> >> Is your favorite EDA tool not on this list? Let us know at >> support AT macrofab DOT net. We're continuously working on instructions >> for new programs, and we'd be happy to prioritize your tool. > > I am planning to hire Macrofab for a run also. > Maybe we should both ask for them to review pcb xy output > and give suggestions on how to use gxyrs. If there's enough active pcb-rnd user interest, I can roll an exporter this weekend.