X-Authentication-Warning: delorie.com: mail set sender to geda-help-bounces using -f
Date: Thu, 2 Feb 2012 15:44:54 -0500
Message-Id: <201202022044.q12KisRp010489@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-help AT delorie DOT com
In-reply-to: <alpine.DEB.2.02.1202022212430.25658@darkeagle.dy.fi> (message
	from =?ISO-8859-15?Q?Jaakko_Kantoj=E4rvi?= on Thu, 2 Feb 2012 22:23:05
	+0200)
Subject: Re: [geda-help] PCB: How can i make pin with copper ring only on
 solder layer. (fwd)
References: <alpine DOT DEB DOT 2 DOT 02 DOT 1202021825210 DOT 21502 AT darkeagle DOT dy DOT fi> <201202021809 DOT q12I9PM0005095 AT envy DOT delorie DOT com> <alpine DOT DEB DOT 2 DOT 02 DOT 1202022212430 DOT 25658 AT darkeagle DOT dy DOT fi>
Reply-To: geda-help AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-help AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk


Might be better to set the copper size to match the hole size, not
less than.  That way DRC is happier.