X-Authentication-Warning: delorie.com: mail set sender to geda-help-bounces using -f Date: Thu, 2 Feb 2012 13:09:25 -0500 Message-Id: <201202021809.q12I9PM0005095@envy.delorie.com> From: DJ Delorie To: geda-help AT delorie DOT com In-reply-to: (message from =?ISO-8859-15?Q?Jaakko_Kantoj=E4rvi?= on Thu, 2 Feb 2012 18:25:33 +0200) Subject: Re: [geda-help] PCB: How can i make pin with copper ring only on solder layer. (fwd) References: Reply-To: geda-help AT delorie DOT com Errors-To: nobody AT delorie DOT com X-Mailing-List: geda-help AT delorie DOT com X-Unsubscribes-To: listserv AT delorie DOT com Precedence: bulk > I'm designing board to be made at home. So vias and pins don't have > plated holes. Also copper on component side is useless. This board > is 2 sided, so I would get more space if pin's copper ring would not > be on useless side. You can make a footprint with different pad sizes on each side by having the pin's copper be the smaller of the two sizes, and adding an SMT pad for the larger of the two sizes. Use the smaller size to keep traces away from the hole, I suppose.