X-Authentication-Warning: delorie.com: mail set sender to geda-help-bounces using -f
Date: Mon, 12 Dec 2011 17:12:56 -0500
Message-Id: <201112122212.pBCMCuUH002913@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-help AT delorie DOT com
In-reply-to: <20111212214103.14650.qmail@stuge.se> (message from Peter Stuge
	on Mon, 12 Dec 2011 22:41:03 +0100)
Subject: Re: [geda-help] Creating a T-shaped pad in PCB
References: <20111212214103 DOT 14650 DOT qmail AT stuge DOT se>
Reply-To: geda-help AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-help AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk


It's OK to overlap the pads a little, to avoid that "small gap" problem.

Otherwise, yes, you're doing it right :-)