From: eplmst AT lu DOT erisoft DOT se (Martin Stromberg)
Newsgroups: comp.os.msdos.djgpp
Subject: Re: in-line assembly syntax for GNU ASM/DJGPP
Date: 29 Aug 2001 07:38:03 GMT
Organization: Ericsson Erisoft AB, Sweden
Lines: 27
Message-ID: <9mi64r$8r5$2@antares.lu.erisoft.se>
References: <09D1E9BD9C30D311919200A0C9DD5C2C03E08A5C AT mcaexc01 DOT msj DOT maxtor DOT com>
NNTP-Posting-Host: merope.lu.erisoft.se
X-Newsreader: TIN [version 1.2 PL2]
To: djgpp AT delorie DOT com
DJ-Gateway: from newsgroup comp.os.msdos.djgpp
Reply-To: djgpp AT delorie DOT com


I'm not an assebly guy so check that what I say is correct.

Cappellini, Tony (Tony_Cappellini AT maxtor DOT com) wrote:

: Would someone help me with the correct asm syntax for DJGPP for the
: following Intel format instructions

: 	mov AX, OFFSET    count

movw 	$count, %%ax

: 	lea   AX, count

This one is hard I think. Perhaps

db 	ADDRESS_OR_OPERAND_SIZE_PREFIX
lea 	$count, eax

will do it. Not sure which size prefix you should use. Note that the
above sequence doesn't make much sense as your in 32-bit protected
mode. Just why would you want to lea a 16-bit register?


Right,

						MartinS