From: asu1 AT cornell DOT edu
Date: Wed, 10 Dec 1997 10:13:40 -0500 (EST)
To: Eli Zaretskii <eliz AT is DOT elta DOT co DOT il>
cc: "A. Sinan Unur" <sinan DOT unur AT cornell DOT edu>, djgpp AT delorie DOT com
Subject: Re: setting up dviwin for djgpp tex distribution
In-Reply-To: <Pine.SUN.3.91.971210163533.11116B-100000@is>
Message-ID: <Pine.SOL.3.91.971210100947.26217A-100000@travelers.mail.cornell.edu>
MIME-Version: 1.0
Content-Type: TEXT/PLAIN; charset=US-ASCII
Precedence: bulk

On Wed, 10 Dec 1997, Eli Zaretskii wrote:

> 
> So if Kpathsea was not used to build dviwin, I won't recommend this in
> general.  If you have access to the sources and the tools that will let
> you rebuild dviwin, it is much easier to adapt dviwin to Kpathsea (I did 
> that with dvivga, and it took about two nights).  Kpathsea is beautifully 
> and clearly documented, which makes it a snap.
> 
> Of course, it would be nice if a DVU previewer could be built entirely 
> with DJGPP tools. dvivga is just a quick hack, to let people who don't 
> have a laser printer preview their documents; it is not good enough for 
> actually reading the documents, because its graphics interface is 
> minimal.

eli, thanks for your response. i must admit i have absolutely no idea 
what is involved in writing a dvi previewer. i was looking at the dvivga 
source last night but i am having a hard time following the flow. is 
there any document or other source of information outlining what is 
involved? where should i look?

  -- Sinan