From: Jim Brooks Newsgroups: comp.os.msdos.djgpp Subject: Re: RHIDE: "Run" menu selection inaccessible Date: Tue, 27 Jan 1998 15:00:26 -0800 Organization: Internet Gateway Corporation Lines: 29 Message-ID: <34CE670A.C8682F6@pop.intergate.bc.ca> References: <34c79ece DOT 4941960 AT usenet DOT umr DOT edu> NNTP-Posting-Host: pm34s25.intergate.bc.ca Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Transfer-Encoding: 7bit To: djgpp AT delorie DOT com DJ-Gateway: from newsgroup comp.os.msdos.djgpp Precedence: bulk Walter Rader wrote: > The only options in Rhide v1.4 I customize relate to the interface: > different text mode, don't move cursor on paste, 5 space tabs, use no > shadows. After I save the options, all is good for a few runs. Then > suddenly when I load any C++ source file, the "Run", "Make", "Link", > and "Build All" menu selections are grayed out. If I delete the > option files, it works again, but sometimes it appears to save the > options as defaults and I have to re-install to compile within the > program again. Any suggestions about what I could be doing wrong? > > Thanks, > Walter Rader > > University of Missouri at Rolla > > If you respond to this message via e-mail, change the address. I think (dangerous move) you need to select the source window. If when I compile, I'm left with window focus on the result window. closing this or switching to the source window brings back the above menu choicesHope this helps Jim Brooks chief poobah