Message-Id: Comments: Authenticated sender is From: "Salvador Eduardo Tropea (SET)" Organization: INTI To: anders DOT ohrt AT star-trek DOT com (Anders Ohrt), djgpp AT delorie DOT com Date: Wed, 14 May 1997 15:57:18 +0000 MIME-Version: 1.0 Content-type: text/plain; charset=US-ASCII Content-transfer-encoding: 7BIT Subject: Re: DJGPP installation Precedence: bulk anders DOT ohrt AT star-trek DOT com (Anders Ohrt) wrote: > I am about to install DJGPP, because I hate windows-enviroment > programming and BC 3.1 isn't enough. But what should I install? I > downloaded the djgpp dir (180Mb) from simtelnet, but lots of that is > junk... I just want an ide that locks like borlands (rhinde?) Yes RHIDE, but read the readme because RHIDE needs the compiler installed. > and > compiler... Again the README.1st file, if you need more information go to my home page and visit the links pages I have links to at least 3 explanations on how to install DJGPP step by step, one of them must work ;-) > Writing simple stuff... Use RHIDE is very similar to BC++ 3.1 just create a little project. > I also want to be able to use > inline 386+ asm code, GCC uses AT&T syntax, so if you need inline asm you'll need to learn more about this syntax, again go to my pages, I have a section in my links to pages related to this topic, the information is more than enough. > and _lots_ of mem (that's why I changed from > BC31)... That's a normal feature of DJGPP programs ;-) > Should I use DMPI? If so, how? You MUST use DPMI, as you say you hate the Loose family you'll need to install CWSDPMI or QDPMI or another DPMI provider, CWSDPMI is in the v2misc dir (and you have it if you downloaded 180Mb man). SET ------------------------------------ 0 -------------------------------- Visit my home page: http://www.geocities.com/SiliconValley/Vista/6552/ Salvador Eduardo Tropea (SET). (Electronics Engineer) Address: Curapaligue 2124, Caseros, 3 de Febrero Buenos Aires, (1678), ARGENTINA TE: +(541) 759 0013