X-Recipient: archive-cygwin AT delorie DOT com X-Spam-Check-By: sourceware.org Date: Sun, 30 May 2010 19:08:48 -0400 From: Christopher Faylor To: cygwin AT cygwin DOT com Subject: Re: "command not found"-For All Commands Message-ID: <20100530230848.GA21673@ednor.casa.cgf.cx> Reply-To: cygwin AT cygwin DOT com Mail-Followup-To: cygwin AT cygwin DOT com References: <28722920 DOT post AT talk DOT nabble DOT com> <28723813 DOT post AT talk DOT nabble DOT com> <28724299 DOT post AT talk DOT nabble DOT com> <20100530205955 DOT GA11159 AT ednor DOT casa DOT cgf DOT cx> <28725344 DOT post AT talk DOT nabble DOT com> MIME-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Disposition: inline In-Reply-To: <28725344.post@talk.nabble.com> User-Agent: Mutt/1.5.20 (2009-06-14) Mailing-List: contact cygwin-help AT cygwin DOT com; run by ezmlm Precedence: bulk List-Id: List-Unsubscribe: List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner AT cygwin DOT com Mail-Followup-To: cygwin AT cygwin DOT com Delivered-To: mailing list cygwin AT cygwin DOT com On Sun, May 30, 2010 at 03:36:59PM -0700, physicist25 wrote: > > >I did send the results of cygcheck...some slight changes since... > >"I ran cygcheck, its also attached as a .txt file. Notice how I had to add a >"/" to the command to run it." > >-sh-3.2# cygcheck -s -v -r > cygcheck.out >-sh: cygcheck: command not found >-sh-3.2# cygcheck/ -s -v -r > cygcheck.out >cygcheck: dump_sysinfo: GetVolumeInformation() for drive D: failed: 112 >-sh-3.2# > > >I did this again, same results except now I dont have to use "/" when i >write "cygcheck", the results of running the command are the same. > >http://old.nabble.com/file/p28725344/nocommandswork.txt nocommandswork.txt This is what that oddly attached file shows: -sh-3.2# cygcheck -s -v -r > cygcheck.out -sh: cygcheck: command not found -sh-3.2# cygcheck/ -s -v -r > cygcheck.out cygcheck: dump_sysinfo: GetVolumeInformation() for drive D: failed: 112 -sh-3.2# That shows you typing the commands but it doesn't show that actual output from the commands. cgf -- Problem reports: http://cygwin.com/problems.html FAQ: http://cygwin.com/faq/ Documentation: http://cygwin.com/docs.html Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple