X-Spam-Check-By: sourceware.org Message-ID: <45DA9942.4050505@swipnet.se> Date: Tue, 20 Feb 2007 07:46:26 +0100 From: =?ISO-8859-1?Q?Jan_Dj=E4rv?= User-Agent: Thunderbird 1.5.0.9 (X11/20070212) MIME-Version: 1.0 To: Angelo Graziosi Cc: cygwin AT cygwin DOT com Subject: Re: FW: Re: [emacs_user AT hotmail DOT com: ***MEMORY-ERROR***: emacs[5172]: GSlice: failed References: In-Reply-To: Content-Type: text/plain; charset=ISO-8859-1; format=flowed Content-Transfer-Encoding: 8bit Mailing-List: contact cygwin-help AT cygwin DOT com; run by ezmlm List-Id: List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner AT cygwin DOT com Mail-Followup-To: cygwin AT cygwin DOT com Delivered-To: mailing list cygwin AT cygwin DOT com Angelo Graziosi skrev: > Jan DjÃrv wrote: > >> It would be a small thing to figure out which part is used on cygwin if >> the config.h was available. > > > Every time that the build of Emacs-CVS is configured with: > > ... ./configure --prefix=... --with-gtk > > it fails when starting (on Cygwin) in this way: > > $ ./emacs-cvs& > > ***MEMORY-ERROR***: emacs[3128]: GSlice: failed to allocate 504 bytes > (alignment: 512): Function not implemented > > (This does not happens using the default LUCID). > > If the 'config.h' requested is that that created at the end of 'configure' > it is attached. > > Hope it can help. Thanks, but it was actually config.h from a Glib build I needed. I have it now so hopefully this will be found soon. Jan D. -- Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple Problem reports: http://cygwin.com/problems.html Documentation: http://cygwin.com/docs.html FAQ: http://cygwin.com/faq/