From: "Colin Eberhardt" To: Subject: 1.5.18: Problem installing automake1.9 Date: Fri, 18 Nov 2005 10:20:45 -0000 Message-ID: <000401c5ec29$c3869ac0$c101a8c0@wexford> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit X-IsSubscribed: yes Mailing-List: contact cygwin-help AT cygwin DOT com; run by ezmlm List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner AT cygwin DOT com Mail-Followup-To: cygwin AT cygwin DOT com Delivered-To: mailing list cygwin AT cygwin DOT com Dear All, I am a first time user of cygwin so I hope this is not a stupid question. I have searched the archives and googled the web but have not found an answer yet. I am hoping to do some C++ development and wish to use GCC, GDB etc... from cygwin. I have installed everything I need, apart from automake1.9. The files are all unpacked, however when the installer runs: "etc/postinstall/automake1.9.sh" The following pops up: "The procedure entry point ___getreent could not be located in the dynamic link library cygwin.dll" I thought that this is the type of error that you see if the wrong versions of files are being used when trying to link or execute components? I am running the installer directly from the cygwin homepage. Any suggestions? Colin Eberhardt Software Engineer eMail: colin DOT eberhardt AT tecsphere DOT com TecSphere Ltd Centre for Advanced Industry Coble Dene, Royal Quays Newcastle upon Tyne NE29 6DE United Kingdom Direct Dial: +44 (191) 270 31 13 Fax: +44 (191) 270 31 09 http://www.tecsphere.com -- Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple Problem reports: http://cygwin.com/problems.html Documentation: http://cygwin.com/docs.html FAQ: http://cygwin.com/faq/