Mailing-List: contact cygwin-help AT cygwin DOT com; run by ezmlm List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner AT cygwin DOT com Mail-Followup-To: cygwin AT cygwin DOT com Delivered-To: mailing list cygwin AT cygwin DOT com Message-ID: <42D33CA2.471DD894@dessent.net> Date: Mon, 11 Jul 2005 20:44:34 -0700 From: Brian Dessent MIME-Version: 1.0 To: cygwin AT cygwin DOT com Subject: Re: How to add 4K of scratch space at the bottom of the stack using C instead of C++? References: <200507112146 DOT j6BLkPWb005944 AT tremex DOT ucdavis DOT edu> Content-Type: text/plain; charset=us-ascii Content-Transfer-Encoding: 7bit X-Spam-Report: -5.9/5.0 ---- Start SpamAssassin results * -3.3 ALL_TRUSTED Did not pass through any untrusted hosts * -2.6 BAYES_00 BODY: Bayesian spam probability is 0 to 1% * [score: 0.0000] * 0.0 AWL AWL: From: address is in the auto white-list ---- End SpamAssassin results X-IsSubscribed: yes Reply-To: cygwin AT cygwin DOT com Yu-Cheng Chou wrote: > I have module.dll that was created by using command line "gcc -shared -o > module.dll module.c" in cygwin. > When I run "msvc-cygload -v -cygwin module.dll" in cygwin, error messages > listed below occurred. As has been already pointed out, you have to load cygwin1.dll first, initialize it, and then load your DLL. The whole cygload thing is for cygwin1.dll only, it will not work for anything else. After the Cygwin DLL has been loaded and initialized you should be able to load your DLL that depends on the Cygwin DLL normally, without any special procedure. If you try to load your DLL directly Cygwin will not be initialized properly, and if you try to locate the Cygwin initialization routine in your DLL it will fail (because it exists only in the Cygwin DLL.) Brian -- Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple Problem reports: http://cygwin.com/problems.html Documentation: http://cygwin.com/docs.html FAQ: http://cygwin.com/faq/