Mailing-List: contact cygwin-help AT sourceware DOT cygnus DOT com; run by ezmlm List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner AT sources DOT redhat DOT com Delivered-To: mailing list cygwin AT sources DOT redhat DOT com Date: Sat, 21 Oct 2000 22:27:47 -0400 (EDT) Message-Id: <200010220227.WAA07517@freenet10.carleton.ca> From: bf250 AT freenet DOT carleton DOT ca (John Sankey) To: cygwin AT sourceware DOT cygnus DOT com Subject: newbie cygwin install Reply-To: bf250 AT freenet DOT carleton DOT ca I must be doing something totally dumb, but I've just downloaded cygwin 1.1.4 setup.exe and all the binaries separately (my phone line isn't reliable enough to use the on-line install), run setup, selected local directory. Setup refuses to install a whole lot of the downloaded things e.g. less (so man doesn't work) and tar (so I can't add anything) - it just offers the choice between Skip and N/A. (But, they are there - the same as the ones it will install.) I have NT4SP3. All the directories seem to be installed OK, mount says things are mounted, and everything setup said it would install seems to be where it should be. BTW, I only want a system to load and use binaries (no development), but when I tried to run setup with only the "user" set of binaries, cygwin crashed with cygwin1.dll not found... No problem with 's - if you can just get me going :) -- Want to unsubscribe from this list? Send a message to cygwin-unsubscribe AT sourceware DOT cygnus DOT com