Mailing-List: contact cygwin-help AT sourceware DOT cygnus DOT com; run by ezmlm List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner AT sourceware DOT cygnus DOT com Delivered-To: mailing list cygwin AT sourceware DOT cygnus DOT com Message-Id: <200004071523.LAA08477@tisch.mail.mindspring.net> X-Sender: startech AT pop DOT mindspring DOT com X-Mailer: QUALCOMM Windows Eudora Pro Version 4.0.1 Date: Fri, 07 Apr 2000 11:29:40 -0400 To: cygwin AT sourceware DOT cygnus DOT com From: Robert Strunce Subject: usertools installation Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" I am running windowsNT service pack 4 I down loaded the usertools.exe from one of your suggested sites. It was down loaded into C:\temp\usertools.exe It is about 3MB. I also read the info on installing. I double clicked on ustertools.exe it created a folder "pft98~tmp" but it did not give me any information that is had done so. I clicked on it a again and noticed that it was infact unpacking some stuff as noted in a small dialog with a thermaometer bar -- it disapeared without any info. Now I have a folder "pft99~tmp". I tried to delete these folders and start over but it deleted everything in them but setup.exe which it will not delete. HOW DO I DELETE YOUR SETUP.EXE??? NEXT , DO YOU HAVE INFO ON HOW TO INSTALL AND WHAT TO EXPECT. THE README FILES I READ ON THE WEB DID NOT HAVE THE CORRECT INFO AS TO WHAT HAPPENED TO ME. SO WHAT AM I DOING WRONG. Any help would greately be appreciated. Regards, Bob Strunce (703-759-2933) ============================================================================ === Robert Strunce || voice: 703-759-2933 Star Technologies Corporation || fax: 703-759-3266 10303 Galpin Court || cell: 703-629-2933 Great Falls, VA 22066 || internet: startech AT mindspring DOT com USA || -- Want to unsubscribe from this list? Send a message to cygwin-unsubscribe AT sourceware DOT cygnus DOT com