Mailing-List: contact cygwin-help AT sourceware DOT cygnus DOT com; run by ezmlm List-Unsubscribe: List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner AT sourceware DOT cygnus DOT com Delivered-To: mailing list cygwin AT sourceware DOT cygnus DOT com Message-ID: <19991008204107.12010.rocketmail@web110.yahoomail.com> Date: Fri, 8 Oct 1999 13:41:07 -0700 (PDT) From: Earnie Boyd Reply-To: earnie_boyd AT yahoo DOT com Subject: Re: make, bash, or cygwin bug? To: cygwin AT sourceware DOT cygnus DOT com MIME-Version: 1.0 Content-Type: text/plain; charset=us-ascii --- Glenn Spell wrote: > On 8 Oct 1999 around 10:12AM (+0200) Kai Henningsen wrote: > > > /bin/sh: \home\gcc-2.95.1\kai\gcc\cc1obj.exe^M: command not > > found > > > > Well, of course. But who told you to append a cr there? > > > > This Makefile line: > > > > CC1OBJ = `$(CC) -print-prog-name=cc1obj` > > I suspect this is (again) a symptom of mixing mingw and cygwin. > The cygwin port of gcc-2.95 does not append the cr. > > If you could figure out how to get 'cygpath' to print the > output instead of mingw-gcc, it would probably work. :-) Or, try SET CYGWIN=... nobinmode ... before starting bash. The [no]binmode switch controls the processing of the pipe and redirect fd's. If you modify this value after you start bash you effect the change only on pipes not redirects. ===== Earnie Boyd Newbies, please visit (If you respond to the list, then please don't cc me) __________________________________________________ Do You Yahoo!? Bid and sell for free at http://auctions.yahoo.com -- Want to unsubscribe from this list? Send a message to cygwin-unsubscribe AT sourceware DOT cygnus DOT com