From: anil DOT kokaram AT tcd DOT ie (Anil Kokaram) Subject: re: attempt to compile x11r6.3 using b19 21 May 1998 08:52:10 -0700 Message-ID: <01bd8404$9ec7ed00$7d56e286.cygnus.gnu-win32@pc125.mee.tcd.ie> Mime-Version: 1.0 Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: 7bit To: Hello all, I have trawled the mailing list archives without success in answer to my question, this could be because I have very little experience with gcc, make etc. I have been trying to compile the x11r6.3 release as per instructions on point 3 of the list of ported software on the cygnus web site. So I installed the patch and did the suggested software link for cc->gcc and untarred xc-1.tar.gz only (obtained from the mit x site). (I have also checked that patched files were indeed patched, and this seems to be so ... although I did not do an exhaustive check). However, after many hours (>2, <4) the make completed, but I could not find a single object file anywhere. Furthermore, runing install (make install) in the xc directory gave the following : ------------------------------------------------------------------ make -f xmakefile install installing in ./include... make[2]: *** No rule to make target `install'. Stop. installing in ./config... make[2]: *** No rule to make target `install'. Stop. installing in ./lib... make[2]: *** No rule to make target `install'. Stop. installing in ./nls... make[2]: *** No rule to make target `install'. Stop. installing in ./programs... make[2]: *** No rule to make target `install'. Stop. installing in ./doc... cd: can't cd to doc make[1]: *** [install] Error 2 make: *** [install] Error 2 --------------------------------------------------------- I noticed that during the initial making of the makefiles, there were many messages like : -------------------- make[4]: Nothing to be done for `Makefiles'. making Makefiles in lib/font/fc... mv Makefile Makefile.bak make[4]: Nothing to be done for `Makefiles'. making Makefiles in lib/font/Speedo... mv Makefile Makefile.bak make[4] ---------------------- it appears as if the make spent a long time repeating the making of files and also there were a couple errors like : ---------------------------------- make[3]: Nothing to be done for `Makefiles'. making Makefiles in doc... cd: can't cd to doc ..././config/imake/imake: not found make[2]: [doc/Makefile] Error 2 (ignored) cd: can't cd to doc make -f xmakefile Makefiles making Makefiles in include ------------------------------------ Can aybody say whether I should have altered some files like site.def in the xc-1.tar.gz distribution? Are there other defaults ofr gcc configuration which I need to set other than what happens when the CDK is installed? Any advice would be much appreciated. Thanks, Anil Dr. Anil Kokaram anil DOT kokaram AT tcd DOT ie Lecturer, Electrical and Electronic Engineering Dept., Trinity College, Dublin 2, Republic of Ireland - For help on using this list (especially unsubscribing), send a message to "gnu-win32-request AT cygnus DOT com" with one line of text: "help".