X-Recipient: archive-cygwin@delorie.com X-SWARE-Spam-Status: No, hits=-3.8 required=5.0 tests=AWL,BAYES_00,DKIM_SIGNED,DKIM_VALID,DKIM_VALID_AU,FREEMAIL_FROM,KHOP_RCVD_TRUST,KHOP_THREADED,RCVD_IN_DNSWL_LOW,RCVD_IN_HOSTKARMA_YE X-Spam-Check-By: sourceware.org MIME-Version: 1.0 In-Reply-To: References: Date: Sat, 21 Apr 2012 18:41:12 -0400 Message-ID: Subject: Re: Change dark blue terminal colour From: Dotan Cohen To: cygwin@cygwin.com Content-Type: text/plain; charset=UTF-8 X-IsSubscribed: yes Mailing-List: contact cygwin-help@cygwin.com; run by ezmlm Precedence: bulk List-Id: List-Unsubscribe: List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner@cygwin.com Mail-Followup-To: cygwin@cygwin.com Delivered-To: mailing list cygwin@cygwin.com On Fri, Apr 20, 2012 at 15:10, Andy Koppe <> wrote: > Assuming you're using Cygwin's default terminal, stick this into ~/.minttyrc: > > Blue=0,0,191 > > And in case you want to change bold blue as well: > > BoldBlue=64,64,255 > > Adjust the RGB values as desired. The values shown are the default ones. > > Andy > Thank you Andy. So far as I know I am using the default terminal, but putting those lines in the file specified did not help. I did close the Cygwin terminal and reopen it. Note that the blue text is being sent over SSH (VIM). I would imagine that for a terminal setting it should not matter from where the text was sent, but I mention it if it is important. -- Dotan Cohen http://gibberish.co.il http://what-is-what.com -- Problem reports: http://cygwin.com/problems.html FAQ: http://cygwin.com/faq/ Documentation: http://cygwin.com/docs.html Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple