Mailing-List: contact cygwin-help@sourceware.cygnus.com; run by ezmlm List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner@sources.redhat.com Delivered-To: mailing list cygwin@sources.redhat.com Message-ID: <15098.43070.866191.946386@coyote.priv.helixdigital.com> Date: Thu, 10 May 2001 07:39:58 -0700 To: cygwin@cygwin.com MIME-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Transfer-Encoding: 7bit In-Reply-To: <3AFA64BB.D515CBCF@certum.pl> References: <3AFA64BB.D515CBCF@certum.pl> X-Mailer: VM 6.76 under 21.1 (patch 12) "Channel Islands" XEmacs Lucid From: Dario Alcocer Subject: Re: Serial Programming >>>>> "Jacek" == Jacek Trzcinski writes: Jacek> Hi Cygwiners !, I need a way to set(get) modem lines on Jacek> serial interfaces (/dev/ttys0 and other)... Jacek> Typical Posix solution for example ioctl(fd,TCGETS,...) or Jacek> ioctl(fd,TCSETS,..) does not work because of absence such Jacek> constants in termios.h under Cygwin Which termio stuff is missing from Cygwin? It would helpful if you were to list what you think is missing. Maybe you could go through your code and determine which ioctl() calls and macros you're using. Then, you could compare that list with what's in the cygwin1.dll source code. The source code for cygwin1.dll is at: ftp://ftp.sunsite.utk.edu/pub/cygwin/latest/cygwin Look at the files names *.src.tar.gz, and retrieve the one that corresponds to the Cygwin version you're currently using. -- Dario Alcocer -- Sr. Software Developer, Helix Digital Inc. alcocer@helixdigital.com -- http://www.helixdigital.com -- Want to unsubscribe from this list? Check out: http://cygwin.com/ml/#unsubscribe-simple