Subject: Re: port of omniorb
From: "edward" <[email-masked]>
To: "Jason Tishler" <[email-masked]>, "bruno patin \(travail\)" <[email-masked]>
Cc: "groupe cygwin" <[email-masked]>
Date: Mon, 2 Apr 2001 02:28:34 -0400

----- Original Message -----
From: "Jason Tishler" <[email-masked]>
To: "bruno patin (travail)" <[email-masked]>
Cc: "groupe cygwin" <[email-masked]>
Sent: Sunday, April 01, 2001 12:37 AM
Subject: Re: port of omniorb

> Check out MICO (www.mico.org), they have or had a Cygwin (b19) port.
> Since, they do use autoconf, it may be as simple as:
>
>     $ configure
>     $ make
>     $ make install
>
> Then again, it may not...
>

Turned out, it *was* that easy, modulo some bug fixes in the demo suite
(redlich/calc-{2,3,4} uses a reference, when it should use a pointer). the
source itself works as far as i can tell, in the very limited time i've
looked at it. at least well enough so that the demo source runs.

p.s. i didn't bother generating dlls. i used static compilations.

mico-2.3.5

cheers,
edward

_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com

--
Want to unsubscribe from this list?
Check out: http://cygwin.com/ml/#unsubscribe-simple