Mailing-List: contact cygwin-help@sourceware.cygnus.com; run by ezmlm List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner@sources.redhat.com Delivered-To: mailing list cygwin@sources.redhat.com X-Apparently-From: Message-ID: <3A8D2A3C.6CDE0F20@yahoo.com> Date: Fri, 16 Feb 2001 08:25:16 -0500 From: Earnie Boyd Reply-To: Earnie Boyd X-Mailer: Mozilla 4.76 [en] (WinNT; U) X-Accept-Language: en MIME-Version: 1.0 To: Andrej Borsenkow CC: Colman Curtin , cygwin@cygwin.com Subject: Re: cscope for Windows NT/95/98 References: <001301c097e6$cf4790e0$21c9ca95@mow.siemens.ru> Content-Type: text/plain; charset=us-ascii Content-Transfer-Encoding: 7bit Andrej Borsenkow wrote: > > > > > > > As far as I remember it compiles ok and runs. > > I was trying to get it to work with Vim but seemingly it uses shared mem to > > communicate, I couldn't get the two to operate - may do now with a later > > version of the ipc daemon. > > try compiling it and see how you get on. > > No, they (vim + csope) do not use shared memory. Vim opens ``cscope -l'' > attached to pty. If this does not work, it may mean > > - vim is not compiled with cscope support (check vim --version) > - there are problems in how vim is using pty under cygwin. What version of > Cygwin are you using? > And, if you need pty support you must have `set CYGWIN=... tty ...' before starting any application including daemons. Note, the tty setting will cause Cygwin to have difficulties in communicating with non-Cygwin programs. Earnie. _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com -- Want to unsubscribe from this list? Check out: http://cygwin.com/ml/#unsubscribe-simple