Mailing-List: contact cygwin-help@sourceware.cygnus.com; run by ezmlm List-Unsubscribe: List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner@sourceware.cygnus.com Delivered-To: mailing list cygwin@sourceware.cygnus.com Message-ID: <38061C9A.E16FBB60@ece.gatech.edu> Date: Thu, 14 Oct 1999 14:10:34 -0400 From: "Charles S. Wilson" X-Mailer: Mozilla 4.7 [en] (WinNT; U) X-Accept-Language: en MIME-Version: 1.0 To: Gabriele Dionisi CC: cygwin@sourceware.cygnus.com Subject: Re: perlcc References: <38060B9A.5ABE0E2@ic.ac.uk> Content-Type: text/plain; charset=us-ascii Content-Transfer-Encoding: 7bit As far as I am aware, perlcc was not truly enabled until some patches were added post-version_61. (I'm surprised you're getting any response at all with verion 5.005_03.) These patches are included in the perl5.005_61 port on the cygutils website. So try that version; hopefully it will work (without GDPro). What is GDPro anyway? Is it a perl module or some separate program? --Chuck P.S. If it turns out that you DO need GDPro - of course there's a way around the version mismatch problem. Rebuild GDPro from source using your new 5.005_61 perl. :-) Gabriele Dionisi wrote: > > I downloaded the binary version of perl > (perl5.005_03-cygwinb20-dynamic-v1.4.tar.bz2) but when I run perlcc it > complains because it can't find some GDPro perl library. I installed the > last version of GDPro but now perlcc complains that the version of the > GDPro library is too old. > Does anyone know how to overcome this problem? > > Thank you very much, > Gabriele > > -- > Want to unsubscribe from this list? > Send a message to cygwin-unsubscribe@sourceware.cygnus.com -- Want to unsubscribe from this list? Send a message to cygwin-unsubscribe@sourceware.cygnus.com