Mail Archives: opendos/2005/01/12/17:51:51
That's just as well, since I don't have any software for configuring
NE2000 clone boards, anyway. <g>
Actually, I was able to figure out the IRQ jumper settings by doing
a bit of circuit tracing. The the I/O address and Boot ROM jumper
settings (and the type of card) I figured out by trial-and-error with
NE*.COM packet drivers (which are very convenient for this purpose,
since they take their parameters from the command line, rather
than a configuration file).
Please see the next message for further developments.
Joe.
> -----Original Message-----
> From: shadow AT shadowgard DOT com [SMTP:shadow AT shadowgard DOT com]
> Sent: Wednesday, January 12, 2005 3:42 PM
> To: opendos AT delorie DOT com
> Subject: RE: PNW vs Netware (and NE2000 drivers)
>
> On 10 Jan 2005 at 19:15, da Silva, Joe wrote:
>
> > Secondly, I tried to identify what network cards I had and what
> > resouces they required (or could be configured to use). Initially, I
> > settled on a pair of SMC 8013EPC cards, until I realized they would
> > use up a 16K memory window, whereas I tend to make full use of my UMB
> > space for various DOS drivers and for EMS. Next, I tried to identify a
> > pair of old 8 bit Novell cards and a pair of (also old) 16 bit Novell
> > cards - AFAICT, these are NE1000 and NE2000 cards, respectively (well,
> > they don't have a recognizable model number, but the NE1000 and NE2000
> > packet drivers are happy to load with them and report their MAC
> > address correctly). Although these cards only support IRQ 2 through 5
> > (I'd have preferred to use IRQ 10), they don't require a RAM window,
> > so are ideal for a DOS environment. Since I expect the 16 bit cards
> > will have better performance over the 8 bit cards, I settled for the
> > (AFAICT) NE2000 cards.
> >
> > Alas, when I tried to load the VLM ODI drivers (NE2000.COM is
> > 1996/04/01 vintage), I got the error message :
> > "The hardware configuration conflicts"
>
> Silly question. Are you sure you have ther *jumpers* on the cards set
> correctly?
>
> Those old cards *don't* software configure.
>
>
> --
> Leonard Erickson (aka shadow)
> shadow at shadowgard dot com
>
-------------------------------------------------------------------------------------------------------
This email (including any attachment) is confidential. If you are not the intended recipient,
you must not disclose or use this email or the information contained herein for any purpose.
If you have received this email in error, please immediately advise us by reply and delete this email.
This email may not be altered, forwarded or re-issued without our consent. AMPY Email Metering is
not responsible for any changes made to this email or the effect of any changes on the email’s meaning.
It is the responsibility of the recipient to scan this email for viruses and faults prior to processing.
AMPY Email Metering shall not be liable for any loss or damage caused by this email from transmission,
viruses, faults or the use of data accompanying this message. AMPY Email Metering reserves all its
rights, including copyright,in this email.
- Raw text -