Mail Archives: opendos/1999/08/26/03:42:13
On Tue, 17 Aug 1999 Andy <aaa AT netcom DOT com> wrote:
> I can't run qedit when using opendos 7.01 through 7.03. I get an error
> message saying that emm386 has detected an error when I try to load qedit.
I am using SemWare's (outdated, but fast and small) QEDIT 2.xx and
TSE Pro 2.5x under Novell DOS 7 - DR-DOS 7.03 and with QEDIT have
not experienced the problems you mentioned. Using TSE under DR-DOS,
however, use of XMS or EMS memory will sometimes cause protection
faults. The behaviour seems to change depending on the size of the
files loaded and the count of task running simultanously. Fiddling
with the various memory options in the TASKMGR.INI file may help,
and switching use of XMS and EMS off in TSE (setting 0) helps too.
Also try to switch EMM386 /DPMI=off /MULTI=off, although this
works OK for me. In any case, check the EMM386 settings so that
you exclude any memory regions in use for ROMs and AddOn hardware
(/EXCLUDE). MEM /AP will give you an overview of the current setup.
> Also, my screenreader will only read the top 3 lines on each screen at
> times. Any suggestions on what could be the problem.
Not actually, because screenreader software is very proprietary.
Does this also happen under MS-DOS? It could be the load order of
the files in CONFIG.SYS is wrong, but without better details it
could be almost anything (including configuration settings of the
screenreader software itself).
Matthias
-------------------------------------------------------------------
Matthias Paul, Ubierstrasse 28, D-50321 Bruehl, Germany
eMail: <Matthias DOT Paul AT post DOT rwth-aachen DOT de>
Web : http://www.rhrz.uni-bonn.de/~uzs180/mpdokeng.html
-------------------------------------------------------------------
- Raw text -