delorie.com/archives/browse.cgi   search  
Mail Archives: geda-user/2018/02/03/11:17:11

X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
Subject: Re: [geda-user] Net length info question
To: geda-user AT delorie DOT com
References: <0a59af1c-d27e-2b2f-f649-fd5f84ae7fc5 AT linetec DOT nl>
<alpine DOT DEB DOT 2 DOT 00 DOT 1802031633270 DOT 12270 AT igor2priv>
From: "Richard Rasker (rasker AT linetec DOT nl) [via geda-user AT delorie DOT com]" <geda-user AT delorie DOT com>
Message-ID: <b9ab4067-447e-9d0b-42ba-1f4cbd5aaeb5@linetec.nl>
Date: Sat, 3 Feb 2018 17:15:30 +0100
User-Agent: Mozilla/5.0 (X11; Linux x86_64; rv:52.0) Gecko/20100101
Thunderbird/52.6.0
MIME-Version: 1.0
In-Reply-To: <alpine.DEB.2.00.1802031633270.12270@igor2priv>
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com

Hello Igor,


Op 03-02-18 om 16:35 schreef gedau AT igor2 DOT repo DOT hu:
> Hello Richard,
>
> On Sat, 3 Feb 2018, Richard Rasker (rasker AT linetec DOT nl) [via 
> geda-user AT delorie DOT com] wrote:
>
>> Question (and the answer is probably 'no', but I'm curious anyway): 
>> with the cursor over the net, is there a way to report the net length 
>> up to the cursor, even when the total length is more? The actual 
>> tubing has markings at every 10 meters, and it would be convenient if 
>> I could duplicate this in the PCB plan -- but it might also be handy 
>> when designing CPU and memory buses for actual pcb's.
>
> I can implement this in pcb-rnd in about 15 minutes, if you are 
> willing to test it using trunk/.

Being a very lazy person, I normally use the geda-unstable package from 
the Mehanik ppa, but I'm absolutely willing to give pcb-rnd a try, and 
yes, this easier net length lookup would be rather handy even for this 
one application.

One question: is building & installing pcb-rnd likely to interfere with 
the package version of pcb or any other gEDA components?
If so, then I'll probably do this in a separate Linux installation that 
I use for experiments (I'm rather dependent on a properly working gEDA 
suite).

But hey, thanks, I'll look forward to this functionality! I'll have to 
figure out how to build pcb-rnd again (I don't do much in the way of 
software builds), but I've done that before, so I should be able to 
figure it out again.

Thanks again,

Richard

- Raw text -


  webmaster     delorie software   privacy  
  Copyright © 2019   by DJ Delorie     Updated Jul 2019