delorie.com/archives/browse.cgi   search  
Mail Archives: geda-user/2016/02/12/16:56:23

X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
X-Virus-Scanned: amavisd-new at cloud9.net
Date: Fri, 12 Feb 2016 16:55:33 -0500 (EST)
From: "Stuart Brorson (sdb AT cloud9 DOT net) [via geda-user AT delorie DOT com]" <geda-user AT delorie DOT com>
To: "Nicklas Karlsson (nicklas DOT karlsson17 AT gmail DOT com) [via geda-user AT delorie DOT com]" <geda-user AT delorie DOT com>
Subject: Re: [geda-user] Stepper Driver Question
In-Reply-To: <20160212224610.201333a012fd6a8c948ac8b9@gmail.com>
Message-ID: <alpine.BSF.2.00.1602121649460.1440@earl-grey.cloud9.net>
References: <CALSZ9grFdpWEWyU2LFhoDfSYCmXatFohBFyxNGfXdS-SnZ7pBw AT mail DOT gmail DOT com> <201602122040 DOT u1CKeFdl011276 AT envy DOT delorie DOT com> <20160212224610 DOT 201333a012fd6a8c948ac8b9 AT gmail DOT com>
User-Agent: Alpine 2.00 (BSF 1167 2008-08-23)
MIME-Version: 1.0
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com

I understand that windings in transformers and coils can vibrate at
the drive frequency.  If the windings are not held perfectly still
(hard to do), then they will vibrate slightly due to the time-varying
drive iteracting with the magnetic field surrounding them, causing
sound.

Old-timers will recall the low hum emitted by 60 Hz transformers in
old radio equipment.

If you stepper motors themselves are making the noise, then it's
likely the windings in the stepper.  If your circuit is making the
noise, it's likely your inductors or transformers.  If the noise
doesn't bother you, ignore it.  If it bothers you, make sure your
inductors and transformers are potted in something.  Of course, this
lowers the current rating 'cause they can't be cooled effectively....

Hope this is useful,

Stuart


On Fri, 12 Feb 2016, Nicklas Karlsson (nicklas DOT karlsson17 AT gmail DOT com) [via geda-user AT delorie DOT com] wrote:

>> Could be the PWM it uses to control current through the coils
>> (remember, steppers have to be powered all the time to avoid losing
>> steps, even when stopped).  Check with a scope and see if it matches
>> the spec.
>>
>> You might be able to silence it with some extra inductance in the
>> wires, either a LC low-pass filter or a ferrite, depending on your
>> design needs.
>
> It is normal for switched power electronics to make sound. Either from the switching or the control loop.
>

- Raw text -


  webmaster     delorie software   privacy  
  Copyright © 2019   by DJ Delorie     Updated Jul 2019