delorie.com/archives/browse.cgi | search |
X-Authentication-Warning: | delorie.com: mail set sender to geda-user-bounces using -f |
X-Recipient: | geda-user AT delorie DOT com |
Message-ID: | <20140610164336.22304.qmail@stuge.se> |
Date: | Tue, 10 Jun 2014 18:43:36 +0200 |
From: | Peter Stuge <peter AT stuge DOT se> |
To: | geda-user AT delorie DOT com |
Subject: | Re: [geda-user] Using PCB with a EDIF/Protel/PADS format netlist |
generated by ORCAD? | |
Mail-Followup-To: | geda-user AT delorie DOT com |
References: | <CAOFvGD6Q-XnRme-tDwDacQKzY1Ragp94hpe+G7Mk4Qzfob6rdA AT mail DOT gmail DOT com> |
MIME-Version: | 1.0 |
In-Reply-To: | <CAOFvGD6Q-XnRme-tDwDacQKzY1Ragp94hpe+G7Mk4Qzfob6rdA@mail.gmail.com> |
Reply-To: | geda-user AT delorie DOT com |
Errors-To: | nobody AT delorie DOT com |
X-Mailing-List: | geda-user AT delorie DOT com |
X-Unsubscribes-To: | listserv AT delorie DOT com |
Jason White wrote: > any scripts floating around out there to convert one of them into the gEDA What would be the best EDIF version to target, if one were to write an EDIF writer for gEDA? Is 4 0 0 supported by pretty much all relevant readers? //Peter
webmaster | delorie software privacy |
Copyright © 2019 by DJ Delorie | Updated Jul 2019 |