delorie.com/archives/browse.cgi   search  
Mail Archives: geda-user/2014/05/26/06:04:36

X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
X-Injected-Via-Gmane: http://gmane.org/
To: geda-user AT delorie DOT com
From: Kai-Martin Knaak <kmk AT familieknaak DOT de>
Subject: Re: [geda-user] change line size: nevermind
Date: Mon, 26 May 2014 12:03:56 +0200
Lines: 20
Message-ID: <llv3id$d73$1@ger.gmane.org>
References: <53827DB4 DOT 5040006 AT neurotica DOT com>
Mime-Version: 1.0
X-Complaints-To: usenet AT ger DOT gmane DOT org
X-Gmane-NNTP-Posting-Host: a89-182-108-148.net-htp.de
User-Agent: KNode/4.11.5
Reply-To: geda-user AT delorie DOT com

Dave McGuire wrote:

> Found it...Select all traces by turning off everything else, select
> all visible, then ":ChangeSize(SelectedLines, 7)". (for 7mils)

IIRC, the size parameter is 1/100 of a mil by default.

I recommend to use the unit parameter to reduce this kind of 
ambiguity. To achieve 7 mil width:
 ChangeSize(SelectedLines, 7, mil)

BTW, in section "actions" the manual still refers to 1/100 mil as the 
internal unit of pcb
	http://pcb.geda-project.org/pcb-cvs/pcb.html#Actions

It only mentions "mm" and "mil". In fact, pcb deals gracefully with 
the usual multiples, too. E.g. "m", "nm", "um", ...
No "ly", though ;-)

---<)kaimartin(>---

- Raw text -


  webmaster     delorie software   privacy  
  Copyright © 2019   by DJ Delorie     Updated Jul 2019