X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
Date:	Tue, 28 Jan 2014 13:28:59 -0500
Message-Id:	<201401281828.s0SISxqg012872@envy.delorie.com>
From:	DJ Delorie <dj AT delorie DOT com>
To:	geda-user AT delorie DOT com
In-reply-to:
	<CALSZ9gpX2W3F+BKTuFgg78u+VAtAaLgwZj1g1hjSLBR5FLumWw AT mail DOT gmail DOT com>
	(message from Rob Butts on Tue, 28 Jan 2014 13:27:40 -0500)
Subject:	Re: [geda-user] 0.5mm pitch connector suggestions
References:	<CALSZ9grNCBNGwof1bXwyFic92HJ15QxFDUiRT8HfLOVB12Q92w AT mail DOT gmail DOT com>
	<52E7C574 DOT 1050300 AT buffalo DOT edu> <CALSZ9gpX2W3F+BKTuFgg78u+VAtAaLgwZj1g1hjSLBR5FLumWw AT mail DOT gmail DOT com>
Reply-To:	geda-user AT delorie DOT com

My only real hint for fine pitch - when you design the footprint, make
the copper stick out a few extra mm so that (1) you can get to it with
your iron, and (2) you can use it to drag solder away from the part
pins when they bridge.

- Raw text -