X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Mailer:	exmh version 2.8.0 04/21/2012 (debian 1:2.8.0~rc1-2) with nmh-1.5
X-Exmh-Isig-CompType:	repl
X-Exmh-Isig-Folder:	inbox
From:	karl AT aspodata DOT se
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] Side-mounted header connector
In-reply-to:	<20140114072906.GE18632@fi.muni.cz>
References:	<20140114072906 DOT GE18632 AT fi DOT muni DOT cz>
Comments:	In-reply-to Jan Kasprzak <kas AT fi DOT muni DOT cz>
	message dated "Tue, 14 Jan 2014 08:29:06 +0100."
Mime-Version:	1.0
Message-Id:	<20140114080501.5CE2E8045B75@turkos.aspodata.se>
Date:	Tue, 14 Jan 2014 09:05:01 +0100 (CET)
X-Virus-Scanned:	ClamAV using ClamSMTP
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

Yenya:
> I would like to use a 2x3 pin, 2.54mm spaced header connector for in-system
> programming of the MCU, but I am pretty restricted in the vertical direction.
> So I considered a side-mounted connector: one row of pins on the top side
> of the PCB, and another row on the bottom side, similar to the header
> on the right side of the following image:
> 
> http://fabiobaltieri.files.wordpress.com/2011/08/usbasp.jpg?w=630
> 
> Is it possible to describe it with a single footprint?

Yes, use a pad on each side like in

http://turkos.aspodata.se/git/openhw/share/pcb/_connector/wascator_edge_3.fp

   Pad[ 10mm -3mm  10mm 3mm  2.0mm 0.5mm 0.2mm "1" "1" "square" ]
   Pad[ 10mm -3mm  10mm 3mm  2.0mm 0.5mm 0.2mm "1" "1" "square,onsolder" ]

Regards,
/Karl Hammar

-----------------------------------------------------------------------
Aspö Data
Lilla Aspö 148
S-742 94 Östhammar
Sweden
+46 173 140 57

- Raw text -