delorie.com/archives/browse.cgi | search |
X-Authentication-Warning: | delorie.com: mail set sender to geda-user-bounces using -f |
Date: | Wed, 3 Jul 2013 15:58:05 -0400 |
Message-Id: | <201307031958.r63Jw5r2025909@envy.delorie.com> |
From: | DJ Delorie <dj AT delorie DOT com> |
To: | geda-user AT delorie DOT com |
In-reply-to: | |
<CACPio-4vTN=XE8XvJibvfA2JfTCG7JShFjaUMapHst6WGm0GrQ AT mail DOT gmail DOT com> | |
(message from Nathan Stewart on Wed, 3 Jul 2013 15:01:12 -0400) | |
Subject: | Re: [geda-user] outline layer not closed |
References: | <CACPio-4vTN=XE8XvJibvfA2JfTCG7JShFjaUMapHst6WGm0GrQ AT mail DOT gmail DOT com> |
Reply-To: | geda-user AT delorie DOT com |
Try making your workspace a little bigger than the outline. PCB's "outline detector" just does a flood fill at the corners of the workspace; if the outline touches those corners it may interfere.
webmaster | delorie software privacy |
Copyright © 2019 by DJ Delorie | Updated Jul 2019 |